Sanitaire SC6010 Guide De L'utilisateur page 4

FlrMachineOG_1618912.qxp_FloorMachine 3/22/19 1:59 PM Page 4
HOW TO SSEMBLE H NDLE ND REMOVE
FLOOR M CHINE FROM BOX
The floor machine comes with a two piece handle in the box. This handle will
need to be assembled before removing the floor machine from the box.
1. Open the box and remove the
cardboard inserts.
2. Lift the upper handle and place it
over the lower handle. Slide the
upper
handle
down
until all
the holes
are
aligned.
3. Slide the washer onto the bolt.
Insert the bolt with the washer into
the aligned holes. If needed, use a
screwdriver to line up the holes to
help
guide
the bolt
through
the
handle.
4. Once the bolt and washers are
through the holes, place the lock
washer
at the
end of
the bolt.
4 www.sanitairecommercial.com
5. Then, attach a nut on the end of the
bolt and fasten tightly.
6. After the handle is completely
assembled, secure the cam lever
by
pushing
it down
to lock
the
handle
in place.
7. After the handle is completely
assembled, secure the cam lever
by
pushing
it down
to lock
the
handle
in place.