Publicité
Les langues disponibles
Les langues disponibles
Press the function button "
desired keep warm temperature, ranging from 40º C to 90º C in intervals of 5 degrees,
using the increase and decrease buttons " +/- " (see figure 6).
Press the start/stop button"
up and then electric kettle will automatically keep the water warm at the selected
temperature for up to 30 minutes and then shut off.
NOTE: If you remove the kettle from the power base, it will reset to its default function,
i.e. Boil.
The kettle will not re-boil until the start button is activated again. Wait 25 seconds,
allowing kettle to cool down, and then press the start.
NOTE: Ensure the lid firmly closed. The electric kettle will not turn off automatically if the
lid is left open.
IF THE KETTLE DOES BOIL DRY
If the kettle is operated in accordance with instructions for use, it is unlikely that the kettle will
boil dry. However, in the event that the kettle does boil dry, it is protected by a boil dry, fail-safe
device which will switch the kettle off automatically on sensing a boil dry situation and keep it
switched off until the kettle is refilled with at least the minimum amount of water. Always allow
the kettle to cool for half an hour before reuse if the kettle has boiled dry.
A mesh filter has been integrated into the kettle to reduce the amount of scale residues
entering your beverages or food. The filter is removable for cleaning. To reduce scale
build-up, empty out any residual water after boiling.
How often the filter should be cleaned will vary according to where you live and how often
you use your kettle. Filter should be cleaned whenever there are noticeable deposits left
on the filter and especially if the rate of pouring decreases.
" to select the keep warm icon and then select the
" to start the heating process. The water will heat
FILTER INSTRUCTIONS
figure 6
English - 7
Publicité
