Uline H-8533 Mode D'emploi page 2

Figure 2
1/4 x 50 mm
Screws
Figure 3
Horizontal Tube
Vertical
Tube
Side Holes
Figure 4
1/4 x 50 mm
Screws
Leg
Assembly
PAGE 2 OF 9
ASSEMBLY CONTINUED
1/4 x 50 mm
Screws
Leg
Connector
Vertical
Tube
Horizontal Tube
Frame
Assembly
1/4 x 50 mm
Screws
3. Connect legs with leg connector. Use two
1/4 x 50 mm screws on each leg. Tighten completely.
(See Figure 2)
4. Insert the vertical tubes into the horizontal tubes.
(See Figure 3)
NOTE: Ensure the side holes in both vertical
tubes are oriented as shown.
5. Slide the frame assembly from step 4 between the
leg assembly from step 3. Align the holes and attach
using two 1/4 x 50 mm screws on each side.
(See Figure 4)
0621 IH-8533