Klarfit Jumpstarter Mode D'emploi page 33

A
A
2
5
Attach the feet assembled in step
2 to the guide frame assembled in
step 3.
7
Place the jumping mat with the
stitched side down in the middle of
the basic frame and fasten a spring in
one of the triangle rings of the mat.
Then attach the other end of the
spring to the frame.
1
A
2
At this point the trampoline should
look as shown in the picture above.
Repeat step 7 directly opposite
where you fixed the first spring.
Then attach two more springs
halfway between the first two
springs, directly across from each
other. This will ensure an equal
tension between the springs.
A
1
A
2
6
8
EN
A
1
33