Publicité
Les langues disponibles
Les langues disponibles
MAINTENANCE MANUAL for WORKSHOP HYDRAULIC
GB
PRESSES
1) LIABILITY OF PRESS OWNER AND/OR USER
This manual is an integral part of the press and must always accompany it, even in the event of
sale. The press owner and/or user must know the operating instructions and recommendations
before using the press. If the operator does not fully understand the language of this manual,
the instructions have to be read and explained in his or her native language making sure the
meaning is understood. The manufacturer shall not be held liable for any damage to per-
sons or objects due to an improper or non-permitted use of the press.
PACKING
The press is shipped in a single pack protected by pluriball plastic material.
Weights of presses:
Mod.
PR10BPM PR10PM PR15BPM PR15PM PR20PM PR25PM PR30EPM PR30PM
Kg.
90
LIFTING AND HANDLING
The presses have to be handled and positioned using fork-lift trucks or workshop cranes that
support the weight.
STORAGE
The packing has to be kept in a covered and sheltered place at a temperature between -10°C
and +40°C.
SAFETY
Do not use the press for purposes other than those for which it was
designed.
Do not work alongside pieces while the ram is moving or when it is
under pressure.
The safety valve is calibrated and sealed by the manufacturer: DO
NOT ATTEMPT TO TAMPER WITH IT AND CHANGE THE SET-
TING.
FAILURE to OBSERVE these RECOMMENDATIONS may cause
even serious damage to the press and/or to the persons working
with it.
THE MANUFACTURER SHALL NOT BE HELD LIABLE FOR DA-
MAGE TO PERSONS OR THINGS CAUSED BY IMPROPER USE
OF THE PRESS OR OF ITS COMPONENTS.
ERECTION (• operations for all types of presses - n operations only for certain types of pres-
ses)
Take the press out of it pluriball wrapping, checking that the machine has not been damaged
during transport and that there are all the pieces indicated in the packing list. The packing mate-
rial has to be disposed of in compliance with the regulations in force in the country where the
press is being erected or recycled or reused.
Fit the feet to the body of the press by screwing them on with the nuts and bolts supplied (Fig. 1).
·
Only for models PR10BPM and PR15BPM fix the press to a solid bench of a suitable capacity
n
load (see press weights), locking it by means of through bolts and nuts to the workbench.
For all other models position the press on a flat and fully levelled surface. Inside the feet there
n
are two holes for fixing to the ground by using expansion plugs of a large cross-section.
10
100
105
120
140
160
PR50PM
195
230
Model
Kg of oil
PR10BPM
PR10PM
PR15BPM
1,2
PR15PM
PR20PM
PR25PM
PR30PM
1,5
PR30EPM
PR50PM
2,4
350
Publicité
