Franke KEPAC-EB Serie Manuel D'installation page 4

SECTION 1: GETTING STARTED
NOT PRE-DRILLED/BOTTLE FILLER KIT:
If the unit is not pre-drilled or you purchased a BOTTLE FILLER retrofit KIT,
go to PAGE 5A.
PRE-DRILLED/PLUMBED:
If your unit was purchased pre-drilled and plumbed at the factory as a COMBINATION, go to PAGE 11C.
WHAT'S INCLUDED?
1. Top cap
2. 38" of 1/4 OD plastic tubing with 19" of sponge tubing insulation
3. Gasket
4. Quick connect tee fitting (only required on split level models)
5. Installation instructions
6. Drip tray
7. Anti splash grate
8. Anti Splash grate screws (2)
9. Snap bushing
10. Wrap-around cabinet facing
11. Hands-free sports bottle filler
2.
3.
4.
5.
11/16 2030003743
1.
10.
11.
TOOLS REQUIRED:
- 3/8" pilot drill and either a step drill bit up to 7/8"
diameter that will drill through stainless steel top or 7/8"
diameter punch die (retrofit version only)
- Electric drill
- Small tubing cutter for copper tube
- T15 Torx driver with pin in head vandal tip
- T20 Torx driver with pin in head vandal tip
- 1/4" nut driver
- #2 Phillips screw driver
6.
9.
7.
8.
4