Power Dynamics PDM-C405A Manuel D'instructions page 5

BACKPANEL
24. Power Input
Connect the included power cord to the AC input connector before switch on the
power.
25. Tape Input
Connect an external device with this RCA input. Signal from external device can be
added to the main output.
26. Record Output
Connect an external device with this RCA output for recording from the main output.
27. Ground Lift Switch
Switch between chassis ground and floating ground.
28. Speaker output A
Connect external passive speaker with one of the speaker connectors.
29. Speaker output B
Connect external passive speaker with one of the speaker connectors.
Note: When using 4 speakers at the same time, use 8~16Ohm speaker. When using
one speaker only, use 4~8Ohm speaker.
CONNECT BT-DEVICE
If password is required, you can enter "0000".
Attention: The BT distance is approx. 10 meter without any barrier.
REPLACING THE FUSE
If the fuse is defective, replace the fuse with a fuse of the same type and value. Before replacing the fuse, unplug mains lead.
Procedure:
Step 1: Open the fuse holder on the rear panel with a fitting screwdriver.
Step 2: Remove the old fuse from the fuse holder.
Step 3: Install the new fuse in the fuse holder.
Step 4: Replace the fuse holder in the housing.
1. Set the search function on of the BT device you want to play the music. See the operating
instructions for that device..
2. Press the "MODE" button and activate BT-function of media player.
3. Find on your BT-device "Power Dynamics" and make the connection.
5