Display Board And Key Functions - Klarstein VINOVILLA SMART Mode D'emploi

EN
30
Temperature Settings
NOTE: The LED displays by default the actual internal air temperature. In the event of
a power interruption, all previous temperature settings are automatically erased and
it will revert to the preset temperature settings.
The electrical board of all models comes with memory function. It is important to
understand that there is a difference between the air temperature inside the wine cellar
and the actual temperature of the wine: You will need to wait approximately 12 hours
before noticing the effects of temperature adjustment due to the critical mass within a full
wine cellar.
Once the temperature is set, it is strongly advised not to toy with it or adjust frequently. The
thermostat will maintain the temperature inside the wine cellar within a +/- 2.5 °C range.
But the thermal inertia of the wine and the glass is such that within this temperature range,
the actual temperature of the wine will only fluctuate 0.5 °C to 1 °C.

DISPLAY BOARD AND KEY FUNCTIONS

Model 10032037, 10040729
1 Display the measured temperature
inside the wine cooler;
2 Each time, the temperature inside
will drop 1 °C, until reduced to a
minimum, and then a return to the
highest temperature.
3 In standby mode: press and hold
for 3 seconds, power is turned on,
the machine starts. In the boot state:
short press this button, LED lights on/
off switch. In the boot state: press the
button for 3 seconds, the power is
off, the whole machine is closed.