Publicité
Les langues disponibles
Les langues disponibles
Installation
1
Rough-in drain & supplies
ROUGH IN SUPPLY AND DRAIN
PIPING AS REQUIRED FOR YOUR
A
INSTALLATION (SEE PAGES 5-6
FOR ROUGH-INS OF OPTIONAL
INSTALLATIONS)
2
Bowl/pedestal mounting and assembly
ATTACH THE STAINLESS STEEL PEDESTAL BASE TO THE PEDESTAL
A
USING SUPPLIED SCREWS AND FINISHING WASHERS. FOR WALL-
MOUNTED MODELS, SEE PAGES 3-4 FOR PEDESTAL HEIGHT.
B
POSITION THE PEDESTAL AT THE DESIRED LOCATION AND MARK THE
POSITION OF THE (4) PEDESTAL WALL MOUNTING LOCATIONS.
SECURE THE PEDESTAL TO THE WALL WITH SUITABLE FASTENERS, 1/2"
C
ANCHORS AND 1/2" BOLTS (SUPPLIED BY INSTALLER) (SEE FIGURE 1B
FOR WALL MOUNTING LOCATIONS).
D
USING TWO PEOPLE, CAREFULLY LIFT THE BOWL ONTO THE PEDESTAL
(SEE FIGURE 4).
E
POSITION THE BOWL SO THAT THE THREADED RODS IN THE BOWL MATE
WITH THE SLOTTED HOLES IN THE PEDESTAL (SEE FIGURE 4).
F
USING 1/4" WING NUTS AND WASHERS, SECURE THE BOWL TO THE
PEDESTAL, THREE PLACES (SEE FIGURE 4).
Figure 4
Bradley Corporation • 215-1332 Rev. U; EN 10-00-002
NOTE:
A location to plug in the 24
VAC transformer is required.
Refer to Figure 1c on page 5
for outlet rough-in.
1-26-10
TDB3103, WF3203
NOTE:
Before attaching 1/4" wing nuts
and washers to threaded rod,
remove red protective caps from
threaded rods. Discard sleeve
caps after removal.
CAUTION:
Bowl surface is smooth.
Aprroximate weight of bowl is 75
pounds. Handle with Care!
7
Publicité
