Connection Of The Remote Switch Cable; Amplifier Input Connection; Aux Connection; Input Sensitivity Control - auna AMP-CH02 Mode D'emploi

EN
16

CONNECTION OF THE REMOTE SWITCH CABLE

• Connect the orange cable to a switched power cable of the car radio.
This controls the switching on and off of the amplifier.
• The switched power cable can serve as the radio's antenna.

AMPLIFIER INPUT CONNECTION

• This unit can be used with all car radios that have high power outputs.
• Separate basic car radio connection: Connect the car radio speaker
output cables to the high-power inputs +/- right and left.
• General car radio connection: Connect the negative car radio speaker
output cable to the two remaining cables +/- right and left.

AUX CONNECTION

• Connect the AUX input cable to the RCA connector as described:
WHITE to the left preamplifier output of the car radio. RED to the right
preamplifier output of the car radio.
• Before connecting the preamplifier output of the car radio or other
equipment, make sure that the impedance and sensitivity match this
AUX connection.

INPUT SENSITIVITY CONTROL

• Control the input sensitivity to the car radio.