Installation (continued)
5
Attaching the quick connector
to the hose
□ After inserting the hose through the hole in the
sink surface, reattach the quick connector (I)
by screwing it onto the threaded end of the
hose (1) in a clockwise motion. Hand tighten
only.
I
1
7
Making the waterline
connections
□ Thread the nut (1) on supply line onto outlet of
water supply valve (2) and tighten with wrench.
Do not overtighten.
6
Attaching the quick connector
to the receiving block
□
Push the quick connector (I) rmly upward and
attach it to the receiving block (1). Pull down
moderately to ensure the connection has been
made.
□
If it is necessary to remove the quick connector
(I), squeeze the tabs on the hose and then pull
down to disconnect.
□
After connecting the hose, install the weights (H)
at the lowest point of the hose.
H
1
2
7
Please contact 1-877-580-5682 for further assistance.
WWW.HOMEDEPOT.COM/PEGASUS
1
I