Installation - Pegasus 65717N-08104 Guide D'utilisation Et D'entretien

Installation

1
Preparing for installation
CAUTION: Always turn off the water supply before
removing an existing faucet or replacing any part of a
faucet. Open the faucet handle to relieve water pressure
and ensure that the water is completely shut off.
□
Shut off the water supply.
□
Before installation, remove the quick connector (I)
from the free end of the hose by unscrewing it in a
counterclockwise direction.
□
Unscrew the nut (D), and remove the
washers (B & C).
NOTE: If installing the faucet assembly (A) without the
escutcheon, begin with step 2. If installing the faucet
assembly (A) with the escutcheon, begin with step 3.
B
C
D
I
A
5
2
Installing the faucet assembly
NOTE: This step is for ange installation (optional). If the
ange will not be used, install the faucet assembly as
described in step 3.
□
Place the ange (E) on the bottom of the new
faucet assembly (A).
□
Retract the hose (1) up through the faucet body
until the hose tting is ush with the bottom of
the shank (2). Do not pull the hose tting past
the shank. Insert the faucet body through the
hole in the sink.
NOTE: Do not feed the hose (1) back down through the
spout until step 5.
WWW.HOMEDEPOT.COM/PEGASUS
Please contact 1-877-580-5682 for further assistance.
A
E
1
2