Hauff-Technik HSI150-DG Instructions De Montage page 9

Contents
1 General information and intended use
2 Safety instructions
3 Description
4 Delivery package
5 Required tools and equipment
6 Installation (exterior side of the building)
1 General and intended use
The HSI 150-DG system cover is suitable for retrofitting and inserting 1 cable with an outer diameter of be-
tween 36 and 70 mm, 1 cable with an outer diameter of between 70 and 112 mm, 3 cables with an outer di-
ameter of between 24 and 54 mm or respectively 6 cables with an outer diameter of between 10 and 36 mm.
2 Safety instructions
Protect the system cover from damage, moisture and contamination during installation. Check
the delivery for completeness and all of the individual parts for any signs of damage. Only un-
damaged parts may be installed.
When installing the system cover, the relevant regulations of employer's liability insurance asso-
ciations, the VDE [Association for Electrical, Electronic & Information Technologies] requirements,
the applicable national safety and accident prevention regulations and the directives (work in-
structions and documented procedures) of your company must be observed.
No cleaning agents containing solvents must be used to clean the cable entries! We recommend
Hauff-Technik M.T.X.60 cable cleaner.
Press seals are not fixed points or bearings and, as such, cannot sustain mechanical forces. Any
anticipated depressions must be compensated for by the installation of centring aids or spacers
in the liners or core drillings (HSI 150-DF aluminium flange).
For the connection of pipes or ducts (DN100/DN125) to the HSI 150 system, the upper applica-
tion range is restricted as a result of the reduction of the clearance / clear width.
3 Description (e.g.: HSI 150-DG-6/10-36)
Sealing plug
Press seal
HSI 150-DG-6/10-36
Cable
9
Middle press plate
HSI 150-K
wall insert
Outer press plate
Adapter ring
GB