EuroLite PL-750 Notice D'utilisation page 9

Rotating the barrel assembly
1.Loosen the barrel rotation knob directly behind the
shutters on the underside of the reflector housing
(Figure 7).Do not remove the barrel rotation knob.
2.Rotate the barrel to the desired position (up to
25° in either direction from the centered position).
3.Once the barrel is positioned, tighten the barrel's
rotation knob to lock it into position.
Installation With Clamp
You can choose a appropriate clamp from your
dealer to fixthe fixture to the mounting pipe and
allows you to adjust the position of the fixture
once it is mounted (Figure 8).
1. Tightly fasten the clamp to the yoke with the
provided yoke bolt and lock washer.
2. Place the clamp on mounting pipe, then
tighten the pipe bolt to secure it.
3. Loosen the clamp pan screw and rotate the
yoke to the desired position.
4. Tighten the pan screw to lock the fixture into
position.
Adjusting the yoke position
The device provides multi-positioning capabilities within
its yoke for overall fixture height and angle.
Setting the fixture height within the yoke
The device has a two-position yoke for modifying the
overall height in which the fixture is mounted (Figure
9). To change the height position, do the following:
1. Remove the yoke locking knobs, washers, and hex
bolts from either side of the fixture.
2. Raise or lower the fixture to the desired position
within the yoke.
3. Replace the yoke's hex bolts,washers, and locking
knobs.
4. Tighten the yoke knobs to secure the fixture in
position.
Setting the angle within the yoke
1. Loosen the yoke locking knobs.(Do not remove
them.)
2. Tilt the fixture to the desired position(Figure 10).
3. Tighten the yoke locking knobs to secure the
fixture in position.
Barrel rotation knob
Pan screw
Yoke bolt and
lock washer
High position
Figure 9
Yoke locking knob
-9-
Figure 7
60#clamp
Pipe bolt
Yoke
Figure 8
Low position
Figure 10