KLASS Fan HELIX Manuel D'utilisation page 20

Table des Matières

Publicité

Les langues disponibles
  • FR

Les langues disponibles

  • FRANÇAIS, page 1
- Attach the LED plate and LED cover
to the light kit base with three screws.
5
- Select the right down rod depending
on the height of your ceiling.
-
If neither of the down rods fits,
contact your fan distributor.
- Remove the screw and bolt from the
hanger ball.
- Remove the locking pin, the two
screws off the coupler.
- Place the downrod through the
coupler cover and the canopy, and
route the electrical cables through the
downrod.
- Install back the screws and bolt to
the hanger ball, ensure to fasten the
screws.
- Insert the downrod into the coupler,
insert the coupling screws and the pin,
tighten the two screws on the coupler
and close with the cover.
6
Hang the fan motor housing on the
mounting bracket, ensure the ball joint
locating the groove aligns with the
notch on the mounting bracket.
- Install the lampshade.
screw
hanger
ball
downrod
tige
canopy
canopy lock
coupler
bolt
Notch
18
pin
power cord
coupler
cover
locking pin
Locating
groove

Publicité

Table des Matières
loading

Table des Matières