LF MATIC 8 Mode D'emploi Et Entretien page 11

Water softener MATIC with AUTOTROL chronometric head 255/440i
INSTRUCTIONS FOR USE
CONTROLS
The system has a valve with a timer where all operation controls are located.
Description of 440i timer
A - Week disc
B - Current day reference
C - Regeneration-setting pins
D - Handle and time disc
E - Current time setting
F - Black control: this control shows the current
phase of the softener.
By activating this control, it is possible to start
a supplementary regeneration
G - Plug or flag: it keeps the timer positioned on
the valve
Description of volume 760 logix timer and 740 logix timer
Timer 740 – Electronic control to perform regeneration on a specific day of the week, or with intervals
ranging from 0.5 to 99 days. This control works either in softener mode or filter mode,
3 cycles with the same timer.
Timer 760 – Timer with electronic statistical volumetric control that regenerates based on water
consumption. A standard function of this timer is the possibility to programme safety
regeneration also without water consumption.
Logix programmers are used on valves 255
A - LCD display
B - DOWN button
C - SET button
D - UP button
E - Start regeneration
Description of electronic simplified timer 366/604
A - Start manual regeneration
B - Display
C - Time setting
D - Salt consumption setting
E - Programming regeneration at days interval
F - Cap closure
G - Indication of regeneration delay/decimal value
H - Position indication
I - Camshaft indicator
9