Preparing To Operate The Appliance; Operating The Appliance; Temperature Control; Lighting - Micromaxx MD 15803 Mode D'emploi

6. Preparing to operate the appliance

 Before using the appliance for the first time, completely remove any packaging
from the appliance and the inside of the appliance.
 Compensate for an uneven surface by unscrewing or screwing in the extendible
feet.
 Clean the inside of the appliance with warm water and a soft cloth.
 Make sure that the storage shelves for the bottles are correctly inserted into the
guide tracks. If necessary, insert the shelves again correctly.

7. Operating the appliance

 Connect the appliance to a properly installed 220-240 V~50 Hz safety socket.
The appliance will beep and the display will show the current temperature inside
the appliance. The appliance will now start to cool the interior.
 Place bottles onto the storage shelves as evenly as possible.
NOTE
The temperature at the bottom storage shelf is a little cooler than at the
top storage shelf. Therefore, place those bottles that need to be cooled
to a greater degree on the lowest storage shelf.
A signal tone is emitted every time a button is pressed.

7.1. Temperature control

 Set the desired temperature (it can be set to between 11°C and 18°C)
 Press
to increase the temperature and
ture.
The set temperature will flash briefly on the display and then the current tempera-
ture inside the appliance will be shown.

7.2. Lighting

 Press
to switch the interior lighting on or off.
NOTE
Leaving the light switched on for a long time will increase the tempera-
ture inside the appliance. Switch the light off immediately when it is no
longer required.
26 of 74
to decrease the tempera-