Assembly Of Gas, Steam And Electric Battery - Domus DTA-45 Mode D'emploi

3.8.

Assembly of gas, steam and electric battery.

Note: A plastic bag containing the necessary bolt stock can be found inside the drum.
Process for the assembly of the gas battery:
1. Remove ceiling pieces 3 and 4 to access side covers 1 and 2 and front
panel 5 which can be found dismounted inside.
2. Mount battery 6 as shown in the drawing and secure with bolts.
3. Pass the sheath B of the thermostat through the bushing A and place it
with the pre-assembled clamp on the battery (see Fig. 1).
4. Mount side panels 1 and 2 with the M5x10 bolts.
5. Mount front panel 5 and ceiling pieces 3 and 4 with the M5x40 bolts.
6. Replace rear cover 7 using the self-tapping screws.
Process for the assembly of the steam battery:
1. Remove ceiling pieces 3 and 4 to access side covers 1 and 2 and front
panel 5 which can be found dismounted inside.
2. Mount battery 6 as shown in the drawing and secure with bolts.
3. Pass the sheath B of the thermostat through the bushing A and place it
with the pre-assembled clamp on the battery (see Fig. 1).
4. Place part 8 (air flow deviator) as shown in the drawing and secure to the
base and then side with rivets.
5. Mount side panels 1 and 2 with the M5x10 bolts.
6. Mount front panel 5 and ceiling pieces 3 and 4 with the M5x40 bolts.
7. Replace rear cover 7 using the self-tapping screws.
Process for the assembly of the electric battery:
1. Remove filter cover to access electric battery 6 found inside.
2. Mount battery 6 as shown in the drawing and secure with bolts.
3. Pass the sheath B of the thermostat through the bushing A and place it
with the pre-assembled clamp on the battery (see Fig. 1).
4. Mount side panels 1 and 2 with the M5x10 bolts.
5. Mount front panel 5 using M5x40 bolts.
6. Replace rear cover 7 using the self-tapping screws.
THERMOSTAT
Fig. 1
BUSHING
SAFETY THERMOSTAT SHEATH
DETAIL C
DETAIL A
DETAIL B
77