Publicité
Les langues disponibles
Les langues disponibles
(Follow figures 1 to 8)
• Use only cold water and a n°4 paper
filter.
• Do not exceed the maximum water
level indicated on the tank.
• This coffee maker is equipped with a
drip stop so that you can serve coffee
before the cycle ends. Replace the
jug immediately in order to avoid
overflowing.
• Wait a few minutes before you make
coffee a second time.
• Do not make another pot of coffee if
the jug already contains coffee.
Thermal pot
• Do not use the thermal pot without
its lid.
• The lid of the isothermal pot must
be closed properly when preparing
coffee and to keep it warm.
• To serve coffee, unscrew the lid half
way.
• Do not put your thermal pot in the
microwave or dishwasher.
• Rinse the thermal pot in hot water
before using so that it retains heat
better and do not put it back inside
the coffee maker after you have
prepared the coffee.
• The thermal pot keeps your coffee
warm for a maximum of four hours.
Setting the time
• Plug in the coffee maker. The LCD
screen (c) will display 12.00 and
flashes for a few seconds.
11
Making coffee
Programming
• Press the H Button in order to set the
hour. You may do this repeatedly, or
continually for faster hour progression.
• AM indicates morning hours and PM,
afternoon and evening hours.
• Once you have set the hour, press the
MINI button for minutes and follow
the same procedure.
• Once the minutes are set, wait for the
flashing to stop and the set time will
be validated. Otherwise, press the
(h) button once.
• The programming will have to be
repeated in case of a blackout or if
the coffee maker is unplugged.
• PLEASE NOTE :You can set or adjust
the time at any moment. Hold the
button down for a minimum of 3
seconds
. Once the time flashes on
the screen, you may adjust the time
using the H and Min buttons.
Program mode
functioning
• In order to program your coffee
maker, press the PROG button once.
• Set the hour and minutes according
to the time you wish your coffee
maker to start (please refer to
"Programming", above).
• Validate the set time by pressing the
PROG button once more.
• The screen will display the set time
and the green light signal (j) will turn
on.
• In order to display the current time
again, briefly press the
• At the set time, the red light signal
will turn on and the coffee maker will
start.
button.
Publicité
