Installing The Front Casing; Electrical Installation; Carrying Out The Wiring - Saunier Duval RED-5 Notice D'installation

5 Electrical installation

4.5 Installing the front casing

1. Mount the front casing at the top of the
wall socket.
2. Use the fixing screw to secure the front
casing.
5 Electrical installation
Only qualified electricians may carry out
the electrical installation.

5.1 Carrying out the wiring

Danger!
Risk of electric shock
There is a risk of electric shock
when working on electrical com-
ponents that are connected to
the low-voltage network.
▶
Disconnect the product from
the power supply.
▶
Secure the product against
being switched back on
again.
▶
Check that the product is
voltage-free.
▶
Only open the product when
it is voltage-free.
1. Remove the front casing. (→ Page 33)
34
1
1 2 1 2 1 2 1 2 1 2 1 2 1 2 1 2
S1 S2 S3 S4 S5 S6 S7 S8
230V 230V R1 R2 R3 R4
N L N L N L N L N L N
5
1 Input
2 Input and output
3 eBUS
2. Connect the required inputs and out-
puts from the selected basic system
diagram.
3. Connect the product using a fixed con-
nection and a partition with a contact
gap of at least 3 mm (e.g. fuses or
power switches).
Danger!
Risk of damage caused by
incorrect installation.
Connecting wires that have
been stripped too far may
cause short circuits and dam-
age the electronics if a strand
accidentally comes loose.
▶
Only strip the outer sheath-
ing of flexible ducts to a max-
imum of 2.5 cm to prevent
short circuits.
▶
Lay the lines correctly.
▶
Use the strain relief.
Installation instructions 0020257175_03
2 3
1 2 1 2 1 2 O I O I - +
S9 S10 S11 S12 S13 BUS
R5 R6 R7/8
R9/10 R11/12 R13
L N L N L N 1 2 N 1 2 N 1 2 N N
4
4 Output
5 Mains connec-
tion