Continental CEFB36H-BS Manuel D'installation Et D'opération page 23

symptom
Ember bed is Brightness not selected.
No difference from Hard wire connections are not
not glowing or
H1 to H2. correct.
Ember LED issue.
dimming.
Main PCB board issue.
Main PCB board issue.
Heating element issue.
LED flashing Appliance has overheated
"OH". Error code "E1". and safety thermal switch has Thermostat issue.
tripped.
problem
See "operation" section.
See "hard-wiring installation" section.
Inspect the ember bed LEDs and replace, if necessary.
Consult your dealer.
Inspect the main PCB board and replace, if necessary.
Consult your dealer.
Unplug power or turn off the circuit breaker. Allow appliance
to cool for 15 minutes, then plug in the appliance or turn the Consult your dealer.
breaker on. If problem persists, consults your dealer.
troubleshooting
solution
W415-2947 / A / 09.01.20
EN
23