Charging The Powerpack Battery; Troubleshooting - FujiFilm SonoSite PowerPack Guide D'utilisation

Charging the PowerPack
battery
A fully discharged PowerPack battery charges in 12
hours if the ultrasound system is turned off. The
system battery charges before the PowerPack
battery charges.
The PowerPack powers the system as well as charges
the system battery (if discharged). If the PowerPack
battery becomes depleted, the system runs on the
system battery.
If the stand is connected to AC power, the system
runs on AC power instead of battery power.
To charge the PowerPack battery
1 Make sure that the following are connected:
• Power supply DC power cord from the stand
(A) to the PowerPack. (See
and connectors" on page 4.)
• PowerPack DC power cord to the system
directly, to the NanoMaxx dock, or to the
mini‐dock (depending on your system and
configuration).
2 Connect to AC power: Connect the system AC
power cord (K) to the stand and a wall outlet.
Note: If using the PowerPark, you connect to AC
power by docking the stand.
The PowerPack battery (and system battery if
discharged) charge regardless of whether the
system is running.
Caution: The PowerPack contains battery
technology that requires periodic
recharging to maintain optimal
performance. If left uncharged for
months, the battery performance
may degrade or become
non-functional.
Indicators
The PowerPack indicators show available battery
power. While the battery charges, an indicator
flashes.
Figure 3 Indicators show available battery power:
1
2
3

Troubleshooting

"PowerPack cables
Symptoms and solutions
PowerPack doesn't charge If the PowerPack ceases
to charge and its indicators are off, it may be in a
frozen state. Disconnect,wait 20 seconds, and then
reconnect the following cords:
•
•
If the problem persists, contact FUJIFILM SonoSite
Technical Support. (See
Technical Support"
Charging takes longer than expected If charging
takes a long time (for example, the charge indicator
is always on), try disconnecting the PowerPack DC
power cord (Z) from the system and running the
system on the system battery only. If the fully
charged system battery discharges quickly (for
example, in a few minutes), it needs replacing.
Contact FUJIFILM SonoSite Technical Support.
1 2
3
Up to 1/3
1/3 to 2/3
At least 2/3
PowerPack DC power cord (Z) from the system
System AC power cord (K), if present, from the
wall outlet
"FUJIFILM SonoSite
on page 1.)
PowerPack User Guide 3