TIPS FOR USE
Before treating delicate or unusual surfaces
with the Steam Disinfector system, consult
the manufacturer's instructions and always
carry out a test on a hidden part or on a
sample of the material.
Allow the steamed part to dry to make sure
that no changes in colour or deformations
have occurred.
Make sure that the surface to be treated is
clean before using the Steam Disinfector. In
the event of visible dirt, clean the surface
before steaming it.
Direct the steam downwards for 2 seconds in
order to bring all the components of the
machine to their correct temperature, in
order to avoid condensation.
Bring the delivery nozzle into a position
perpendicular to the surface to be treated
and keep it at the distance provided by the
spacer bracket / support (5), avoiding direct
contact of the latter with the surface (fig.3).
Deliver
the
steam
movement, using "brushing" movements to
cover the surface to be cleaned.
Repeated treatments will lead to more
efficient treatment of surfaces.
Steam Disinfector delivers steam at a high
temperature that, added to HPMED, will dry
without leaving residues within 30 seconds to
1 minute, depending on the environmental
conditions.
Before starting to use the device, make sure
that the material to be treated can withstand
high temperatures.
CONNECTION OF ACCESSORIES
To connect the accessories to the delivery
device, proceed as follows:
Straight extension accessory (A)
Curved extension accessory (B)
Bring the accessory chosen into line with the
delivery device nozzle (4) and rotate the
accessory until it locks into place (fig.4)
STORING THE DEVICE
When you have finished using the device, put
it away in a clean and dry place after
disconnecting it from the power mains. Keep
it away from sources of heat and protect
from the weather. Do not expose the device
to extreme temperatures.
STEAM DISINFECTOR
on
a
continuous
MAINTENANCE
Before carrying out any maintenance on the
device, always unplug it from the power
mains and allow it to cool down before
proceeding.
• For cleaning the outside of the device we
recommend using a damp cloth. Do not use
solvents or detergents as these could
damage the surfaces.
• If the monotube is torn, it must be replaced
by an authorised service centre.
CLEANING OF THE DELIVERY
NOzzLE
Clean the delivery nozzle every 10-15 hours of
use.
Clean the delivery nozzle using the brush (E)
included in the supply, sliding it inside the
tube so as to remove any residues of scaling
in it (fig.5).
8