HP LC3260N Mode D'emploi page 56

sa6ldtv.book Page 46 Tuesday, February 21, 2006 12:35 PM
Symptom (Continued)
The unit cannot be operated.
The color is strange, faded, or
misaligned.
The power suddenly turned off.
Viewing questions
Symptom
I get a poor picture with video signal
input.
There is no picture or a black screen,
and I have an external device
controlling the TV.
The picture, with a component input
source connected, is too red, blue, or
green.
46
HP LCD HDTV User's Guide
Remedy
External influences such as lightning and static electricity may cause
■
improper operation. In this case, operate the unit after first turning
on the power of the TV or unplugging the AC cord and replugging it
in after 1 or 2 minutes.
Adjust the picture tone.
■
Is the room too bright? The picture may look dark in a room that is
■
too bright.
Check the input signal setting.
■
■ If watching a component device, make sure the red, blue, and green
cables are fully inserted into the proper connectors on both ends.
Is the sleep timer set?
■
Check the power control settings.
■
The unit's internal temperature has increased. Remove any objects
■
blocking the vent, or clean the vent.
Remedy
Check the following: Improper control setting. Local interference. Cable
interconnections. Adjust picture control as needed. Try another location
for the TV. Be sure that all connections are secure.
■ Press the Source button on the remote control and confirm the source
is selected.
Verify that the external device power is turned on.
■
Check to see whether the source component is connected.
■
Check the power management function. Is it in standby mode?
■
Connect the source to the TV. Operate the external device.
■
Check to make sure each cable is plugged into the correct color-
■
coded connector on the TV connectors and input source connectors.
Make sure the cables are plugged in all the way.
■