VEAB Heat Tech ROBUST H Serie Installation Et Utilisation page 5

ROBUST - H
GB
Safety instructions for all models
If the fan heater is incorrectly installed and/or used, it may give rise to danger.
This appliance is not intended for use by persons (including children) with reduced physical, sensory or mental capa-
bilities, or lack of experience and knowledge, unless they have been given supervision or instruction concerning use of
the appliance by a person responsible for their safety.
Children should be supervised to ensure that they do not play with the appliance.
Caution!
• Some parts of this product can become very hot and cause burns. Particular attention has to be given
where children and vulnerable people are present.
• Incorrect installation may cause personal injury.
• Do not use this fan heater in the immediate vicinity of a shower, bathtub or swimming pool.
• The fan heater must not be covered, since this may cause overheating and involve the risk of fire (see also Figure A).
• The fan heater must not be located immediately below or in front of a power socket.
• The plug/CEE connector must be readily accessible.
• Place the fan heater so that any combustible material in the vicinity will not be ignited.
• When work is done on the fan heater or when electrical work is done, the power supply to the fan heater must al-
ways be isolated.
• Work on the heater, such as removing the cover, etc., may be done only by authorized personnel.
• If the power supply cable of the fan heater is damaged, it may be changed only by authorized personnel.
• When the cover is being fitted, tighten the screws 2 ½ turns after the screw gasket has been nipped, in order to
maintain the IP classification of the fan heater.
Technical specification of the Robust H
Total
Robust
power
model
(W)
H6N 6070
H6 6080
H9 9080
A
Heat Motor
Control steps
output rating
(W) (W)
6000 70
6000 80
9000 80
Voltage
(kW)
0-3-6 230V3~
0-3-6 400V3N~
0-4,5-9 400V3N~
5
Important!
When using heater as a portable,
the brackets on the heater should
be swung out of the way and the
bracket holder removed as per
instructions on page 7.
Air flow
Current
rate
(A)
(m³/h)
7,8/15,4 1000
4,5/8,9 1000
6,7/13,2 1000
Air temp.
Weight
rise.
(kg)
(°C)
24 19
24 19
25 19