Operational Modes - Husky HD219000 Instructions D'utilisation

Operating Instructions
Operating The Nailer
(Continued)
NO-MAR DECKING TIP
The no-mar decking tip is designed to
eliminate marks caused by the serrated
work contact element (WCE). The no-
mar tip may be removed if not
required (See REMOVING NO-MAR
DECKING TIP). Use tool in single cycle
mode (SEE OPERATIONAL MODES)
when no-mar tip is in place.
REMOVING NO-MAR DECKING TIP
1. Disconnect air
supply from
nailer.
2. Remove all fasteners from
magazine (See UNLOADING THE
NAILER).
3. Remove no-mar tip retaining ring.
Retaining
Ring
No-Mar Tip
4. Pry no-
No-
mar tip
Mar
away
Tip
from the
work
contact
element.
5. Replace
retaining
ring onto
no-mar
tip, then
store tip
in safe
place for future use.
INSTALLING NO-MAR DECKING TIP
1. Disconnect air
supply from
nailer.
2. Remove all fasteners from
magazine (See UNLOADING THE
NAILER).
3. Remove
retaining ring
from no-mar
tip.
4. Carefully place
no-mar tip over
the end of
work contact
element.
Position tip
onto WCE
making certain
serrated gooves
on each piece are in line and fit
snugly together.
5. Position
retaining ring
on no-mar tip
and press firmly
in place.
6. Check that the
WCE and
trigger move up
and down
freely without
sticking or
binding.

Operational Modes

operational mode of the nailer before
using. Failure to know the operational
mode could result in death or serious
personal injury.
SINGLE CYCLE MODE
This method is
Work
recommended
Contact
Element
for precise nail
placement. This
mode requires
the trigger to
be pulled each time a nail is driven. The
nailer can be actuated by depressing the
WCE against the work surface followed
by pulling the trigger. Or the nailer can
be actuated by pulling the trigger and
then depressing the WCE against the
work surface.
The trigger must be released to reset
the tool before another nail can be
driven.
WORK CONTACT ELEMENT (WCE)
operation of the Work Contact Element
(WCE) trip mechanism before each use.
The WCE must move freely without
binding through its entire travel
distance. The WCE spring must return the
WCE to its fully extended position after
being depressed. Do not operate the
nailer if the WCE trip mechanism is not
operating properly. Personal injury may
occur.
1. Disconnect
Grooves
2. Remove all
3. Make sure the
4. Reconnect air
5. Depress the
Always
know the
6. Remove the
1 2
7. Pull the
Check
the
8. Depress the
4
the air supply
from the
nailer.
nails from the
magazine (see
Loading/
Unloading).
trigger and
work contact
element (WCE)
move freely up
and down
without sticking or binding.
supply to the
nailer.
Work Contact
Element (WCE)
against the
work surface
without
pulling the trigger. The nailer
MUST NOT OPERATE. Do not use
the tool if it operates without
pulling the trigger. Personal injury
may result.
nailer from the
work surface.
The Work
Contact
Element (WCE)
must return to its original down
position. The nailer MUST NOT
OPERATE. Do not use the tool if it
operates while lifted from the work
surface. Personal injury may result.
trigger and
depress the
work
1
contact
element (WCE) against the work
surface. The nailer MUST NOT
OPERATE.
Work
Contact
Element
1
(WCE)
against the work surface. Pull the
trigger. The nailer MUST OPERATE.
Movement
2
2