Grundig MT 8240 Manuel page 25

OPERATION ______________________________
Note
The appliance can be used on wet
7
skin in the shower and cleaned
under the tap (only in battery mode,
see section cleaning the shaving
head).
Cutting hair
Please use the ceramic/stainless steel
A
cutting head (width 38 mm).
1 If necessary, remove the attachment
by pressing in both side catches
and lifting off.
2
Insert ceramic/stainless steel cutting
A
head
press down until it clicks into place.
3
Place a towel around the neck and
shoulders of the person whose hair
you are trimming.
4 Make sure the person is seated so
that their head is roughly at your eye
level. Before trimming, comb the hair
so that it falls naturally and you can
see the direction in which it grows.
5 Press the
appliance and start cutting your hair.
6
Press the
appliance after use.
Beard trimming
Please use the beard trimming attach-
7
ment (width 30 mm).
B
1
If necessary, remove the attachment
by pressing in both side catches
and lifting off.
2
Insert beard trimming attachment
carefully at the top and press down
until it clicks into place.
carefully at the top and
C button to switch on the
C
button to switch off the
ENGLISH
B
7
25