Installing A New Bag; Compactor Care; Cleaning - Jenn-Air TC507 Guide D'utilisation Et D'entretien

Installing a New Bag

IMPORTANT:
Before installing a new bag, be sure:
The drawer side is securely locked.
The container is clean and free of debris.
Do not use any kind of bag other than those designed especially
for use in your compactor. Order replacement compactor bags
through your local dealer or by calling the toll-free number on the
cover or in the "Assistance or Service" section.
1. Place folded bag into the drawer. Open bag and pull top
edges over the drawer top.
2. Lock bag in place by pulling the four prepunched holes over
the bag retainer buttons. Holes will expand over the buttons
without damaging the bag.
3. Press inside of bag against the drawer bottom, sides and
corners for a smooth fit.

COMPACTOR CARE

Your new compactor is designed to give you many years of
dependable service. However, there are a few things you are
expected to do in order to maintain your compactor properly.
This section will tell you how to clean and care for your
compactor.

Cleaning

Before cleaning the compactor, turn the Key-Knob (or Key-
Switch) to the OFF & LOCK position and remove it.
NOTE: Any services other than those outlined in this section
should be performed by a designated service representative.
Cleaning Exterior Surfaces
1. Wash exterior surfaces (including stainless steel) with a clean
sponge or soft cloth and a mild detergent in warm water. Do
not use abrasive or harsh cleaners. Rinse and dry thoroughly
with a soft cloth.
2. Wipe up spills right away. Some foods can damage the finish
if left on the compactor surface.
All manuals and user guides at all-guides.com
NOTE: You may want to wear protective gloves as there may be
bits of glass in the drawer.
1. Remove the bag. (See the "Removing a Filled Bag" section.)
2. Press down on the lever-action lock (or Side-Lock latch).
3. Hold the lever-action lock down and tilt the side of the drawer
4. Wash the interior of the drawer with a clean sponge or soft
5. If the drawer side was removed, slide it back into the tilted
6. Press the lever-action lock (or Side-Lock Latch) down while
7. Latch the drawer side by pushing up the lever-action lock (or
NOTE: You may want to wear protective gloves as there may be
bits of glass in the cabinet.
1. Pull the drawer out until it stops.
2. Lift the front of the drawer to clear the stops.
3. Grasp the drawer on the sides and pull it out the rest of the
Cleaning Inside the Drawer
out until the lock clears the drawer front.
NOTE: If desired, the drawer side can be removed by tilting it
up, then lifting it out.
cloth and a mild detergent in warm water. Rinse and dry
thoroughly with a soft cloth.
position.
pushing the drawer side to the upright position.
Side-Lock Latch).
Cleaning Inside the Cabinet
NOTE: Look to see how the drawer rollers move in the tracks.
It will be easier to replace the drawer when you are finished
cleaning.
way. Set the drawer down gently.
11