Stadler Form Paul Mode D'emploi page 13

distance of at least 100 cm to showers, bathtubs, water faucets, washba-
sins, etc.
1. Having set up Paul in the desired position connect the cable (1) to the
household supply socket.
2. First, push the main switch for power supply (4) on the back of the ap-
pliance.
3. Switch on the appliance by pressing the On/Off button (6). The target
temperature appears on the display.
4. The target temperature can be changed from 0 °C (cooling mode) to
26 °C or maximum «Hi» by making a vertical sliding movement across the
right-hand control panel for selection of temperature (8) «Temperature».
The heating mode is active from 1 ° – 26 °C & «Hi». The digit flashes in
configuration mode. Making a sliding movement upwards or typing «+»
in the upper field increases the target temperature. Making a sliding
movement downwards or typing «–» in the lower field reduces the tar-
get temperature. The setting is saved if no change occurs on the control
panel for selection of temperature for three seconds. The current room
temperature is subsequently shown on the display.
Info: The appliance switches off the heating element when the target
temperature is reached and the temperature indicator flashes on the
display. The ventilator remains switched on at the lowest level in order
to monitor room temperature. The appliance switches on again if the
room temperature recorded drops below the set target temperature.
5. Cooling mode: the heating element switches off if the temperature is
set to 0 °C and the ventilator blows cool air out of the appliance. The LED
light (7) changes from red to blue. There is no temperature shown on the
display in cooling mode.
6. The heat output level can be changed from low to high by making a
vertical sliding movement across the left-hand control panel for selec-
tion of heat output level (9) «Power Level». The display flashes during
the input process. Making a sliding movement upwards or typing «+» in
the upper field increases the output level. Making a sliding movement
downwards or typing «–» in the lower field reduces the output level. The
setting is saved if no change occurs on the control panel for selection
of heat output level for three seconds. The current room temperature is
subsequently shown on the display.
7. Auto mode is activated by pressing the «Auto Mode» button (10). «Auto
Mode» is shown in the display. The preset target temperature of 22 °C
can be changed using the right-hand control panel for selection of tem-
perature (8). The heat output level is selected automatically in auto
mode - depending on the room temperature. The smaller the difference
between the room temperature and the target temperature, the smaller
the heat output level selected. We refer to this as «Adaptive Heat
technology and we have filed for an international patent. This allows
Paul to make sure that the target temperature is reached, quickly and
efficiently, and maintained. Paul thus prevents a sharp temperature drop
and prevents the appliance from being constantly switched on and off.
Auto mode is deactivated if the heat output level is changed manually
(9).
Info: The appliance switches off the heating element when the target
temperature is reached and the temperature indicator flashes on the
display.
»
TM