PNI SP1000W Manuel Utilisateur page 7

correct and the inverter is working properly.
The correct connection of the inverter is shown in the following diagram.
Caution
1. Do not use the AC output of the inverter to connect it to the 230V mains,
so as not to burn the inverter.
2. Connect the loads one by one and do not exceed the declared maximum
power of the inverter.
3. For inductive loads choose an inverter with a maximum power 2-3 times
higher.
4. It is recommended to start the car only with the inverter turned off, because
this procedure will consume a lot of current and can affect the inverter.
5. The inverter must be mounted in a ventilated place, must not be covered
and must be protected from access by people.
6. Do not connect the inverter to discharged, defective or old batteries, as
this may cause the inverter to burn out.
About battery
A storage battery or accumulator is a device that generates energy following
a chemical process. Make sure you have chosen a suitable battery for this
inverter, to ensure a correct and optimal operation.
7 User manual