PNI L1200W Manuel Utilisateur page 7

4. Connect a load to the power outlet of the inverter on the side panel.
5. Ensure all the connections are properly done, turn on the inverter. If the
green LED lights on, then the output voltage is correct and the device is
ready to use.
The correct connection is shown in the below picture.
Cautions
1. Do not use alternating current output to connect power grid, or would
cause frying the inverter.
2. Make sure the power loads increase gradually and do no go over rated
power of the inverter.
3. For inductive loads use a inverter 2-3 times it's power.
4. Because the vacuum pump and electromotor start current is too
strong, the inverter shoud be turned off when you start the car.
5. The inverter should be kept in well ventilated places, not covered by
anything and kept away from touching it.
6. Do not connect the inverter to discharged or old batteries, or it will
cause frying the inverter.
Installation environment
1. Keep the inverter in a well ventilated and clean place.
2. Keep inverters away from water, direct sunlight, dirt and fog.
3. Operating temperature is -26˚C•80˚C.
User manual PNI L1200W
EN
7