Ebode EM Guide Utilisateur page 7

Transmitter - Wall-Mounted Remote Control
After setting the House Code, the Yellow LED will blink 3 times,
which means the House Code is set and the module has left the
program mode.
To now set the Unit Code, start from step A but skip step B and
go directly to step C.
C. Configuring the Unit Code
Stop
Press and release the ON key the appropriate number of times for
the Unit Code you want to set. Once for 1, twice for 2 etc.
The factory setting will be "1 = 1 Green Blink"
After setting the UNIT Code, the yellow LED blink 3 times, which
means the Unit Code is set and the module has leave the program
mode.
Mounting the EM switch to the wall
1. Use a screwdriver to remove the mounting plate
from the switch cover. Be careful not to damage the
electronic circuit.
2. Attach the mounting plate to the wall using e.g.
double sided tape or 2 screws (2 mm) etc.
3. Reattach the cover to the mounting plate. Make
sure the ebode logo is on the right bottom.
When changing the battery, the address will be retained.
Operating the EM module
Check the address.
Simultaneously press the On and Off button shortly to check the
address.
e.g.: for B3 the red led will blink 2 times for the house code and the green led will
blink 3 times for the unit code. Wait until the yellow led blinks 3 times to indicate
the module has left the program mode.
Short press on the ON button, receivers with the same address will power on or
open (when used with shutter).
Short press on the OFF button, receivers with the same address will power off or
close (when used with shutter).
July 2009 page 7
Ref : EM
EM