Kicker ZXM450.2 Guide Du Propriétaire page 3

at the RCA output, which effectively passes the audio signal to another amplifi er or component. Keep the audio
signal cable away from factory wiring harnesses and other power wiring. If you need to cross this wiring, cross it
at a 90 degree angle.
core conductor
source unit
high-level speaker
outputs
+
–
Install a fuse within 18" (45cm) of the battery and in-line with the power cable connected to your amplifi er. If you
ever need to remove the amplifi er from the vehicle after it has been installed, the ground wire should be the last
wire disconnected from the amplifi er--just the opposite as when you installed it.
Model External Fuse
ZXM450.2 1 x 60 Ampere
GND REM +12V
STEREO OPERATION
minimum impedance of 2 ohms per channel
2010 ZXM 450.2 RevC.indd 3 2010 ZXM 450.2 RevC.indd 3
to amplifi er
shield
Power/Ground Wire
4 Gauge
remote turn-on
(see page 5)
KICKER ZISL
OR
source unit high-level
speaker outputs
protection LED
18"
(45cm)
external fuse
L R L R
SPKR + SPKR - SPKR +
L+ L– R+ R–
signal in signal out
to amplifi er
12V
battery
SPKR -
3
10/29/2009 12:58:33 PM 10/29/2009 12:58:33 PM