SERVODAN 23-080 Mode D'emploi page 3

GB
Wireless Foto Gong 23-080
Description
Photo Gong unit 23-080 is a door chime with inbuilt
wireless receiver technology.
The receiver has three different chimes each with its
own LED. That way it can identify three different
transmitters. When the receiver receives a signal
from a particular transmitter, a gong sound chimes
and the associated LED lights up. The gong chime
indicates the presence of a person via a wireless
door button or wireless PIR sensor.
A flexible solution that indicates the presence of
people and can be used in homes, small offices,
businesses and shops.
Wireless Photo Gong 23-080 combines radio frequency
technology and batteries in a wireless system.
- 50 metre range for large areas.
- Positioning as required and no additional
installation.
- Suitable for different premises: in the home,
office, workplaces and small shops.
- 48 possible channel combinations reduces
signal interference considerably.
Channel setting
The transmitter and receiver communicate with each
other by using the same channel. The transmitter is
factory set to system channel "1" and product
channels "7", "9" and "11". You should ensure that both
channels are the same on transmitter and receiver.
In this way the user can select the particular
transmitter units to be connected to channels "7", "9"
and "11" respectively. Fig. 2.
If the user requires a different channel setting,
because other systems are using the same channel,
the user must change the channels on both
transmitter and receiver.
Use the following procedure to change channels:
1. Remove the battery cover on the bottom. Fig. 1
2. Set the system channel to the required
position if necessary. Fig. 2
3. Refit the cover on the bottom. Fig. 4
Press button
with finger
Fig. 1
System Product
channel channel
Fig. 2
Fig. 3
Fig. 4
Installation
1. Fit the wireless unit 23-080 higher than 1 m
above the floor, as the floor will absorb the
transmitter signal and reduce the range. A
position high above the floor provides the best
reception conditions. Fig. 5
2. Position the transmitter and receiver within the
effective range.
3. Position the receiver at least 1 metre from parts
of the building that conduct electricity, such as
aluminium doors and windows, metal sheeting
and electrical cables.
4. Avoid thick walls and metal fences that can
screen and block the radio waves and reduce the
range.
Several receivers should be fitted at least 2 m apart,
in order not to reduce the range to the transmitters.
Keyhole
Fig. 5
Function and operation
The wireless unit 23-080 has three LEDs and three
chimes. Fig. 6. The unit can receive from three different
transmitters in three different places and allows each
transmitter to have its own chime. The LED lights and
indicates which channel has transmitted. The LED
goes out after 10 minutes or can be switched off by
pressing the LED reset button. Fig. 6.
A potentiometer controls the loudness of the chime,
as well as switching it on and off. Fig. 6.
If a signal is received from a transmitter's product
channel 7, the receiver will emit a "ding".
If the transmitter's product channel is 9, the receiver
will emit a "ding-dong".
If the transmitter's product channel is 11, the receiver
will emit a "Westminster" tune. Fig. 6.
The receiver cannot emit a new tune until the previous
one has finished.
Ding
Ding-Dong
Westminster
LED reset
LED light
Soundlevel On / Off
Adapter
Fig. 6