Publicité
Les langues disponibles
Les langues disponibles
GENERAL SPECIFICATION
Max. Jaw Opening:
Max. Conductor Size:
Power/Low Voltage Indication:
After you turn on the Current Probe, the LED will light as a power
indicator if the battery is high enough. If this LED does not light, the
battery is low and must be replaced immediately.
Battery:
IP Degree:
Storage Temperature:
Operating Temperature:
Relative Humidity:
Altitude:
Size:
Weight:
Pollution Degree:
Measurement Category:
REPLACING THE BATTERY
To avoid personal injury, always ensure that the Current Probe
has been removed from any live electric circuit, and the output cable
or other object before opening the battery cover or the case.
Never operate the Current Probe with the battery cover or portions
1. If the LED does not light when the range switch is in 30A
position, the battery is low and must be replaced immediately.
2. To replace the battery, set the range switch in OFF position to turn off
the Current Probe.
3. Remove the screw on the battery cover and remove the battery cover.
4. Replace the exhausted battery with a new one of the same type.
5. Reinstall the battery cover and the screw.
12
NU-720.P30_0617 OK.indd 12
WARNING
has been disconnected from any display device
of the case removed or loosened.
21mm (approx.)
Ø 19mm (approx.)
9V battery, NEDA 1604 or 6F22, 1 piece
IP20
-20°C to 70°C
0°C to 50°C
0% to 80%
0 to 2000 meters
256 x 85 x 50 mm (for main body only)
About 394g (including battery)
2
CAT IV 600V
or 30A
03/07/2017 11:52:24
Publicité
