Linksys Broadband Serie Guide De Démarrage Rapide page 5

Step 1: Connect the Router
In Step 1, you will connect the Router to your cable or DSL modem and to your
home or business computers.
First, make sure that all devices you'll be working with are powered down, includ-
ing your PCs, modem, and the Router.
A. If you haven't already done so, connect your cable or DSL modem to its prop-
er connection—the coaxial jack for cable (Figure A
(Figure A ). (Follow the instructions from your cable or DSL modem's installa-
2
tion guide.)
A
1
B. Using an Ethernet cable, connect the
LAN or Ethernet port of the cable or DSL
modem to the Router's WAN port.
6
Instant Broadband™ Series
), or the phone jack for DSL
1
A
2
B
EtherFast ® Cable/DSL Wireless-Ready Router with 4-Port Switch
C. Connect an Ethernet cable to
your PC's Ethernet adapter.
Connect the other end of the
cable to one of the Router's
LAN ports. Repeat this process
for every PC you wish to con-
nect to the Router.
Note: If your PC's Ethernet adapter is not set up, please refer to the Ethernet
adapter's documentation for more information.
For ease of installation, start with LAN
Port 1 on the Router, then Port 2, Port 3,
and finally Port 4.
N N o o t t e e : : If you have a Linksys Wireless PC Card (WPC11), be sure to fully insert
it into the PC Card slot on the back of the Router before turning on the power.
You must have this card inserted in order to use the Router's wireless fea-
tures.
D. Connect the power adapter to the Router's Power port. Then, connect the
power adapter to an electrical outlet. Turn on the cable or DSL modem. Then
turn on the first PC you wish to use when configuring the Router.
Proceed to Step 2: Configure the PCs on the next page.
C
1
C
2
7