V 2.0
11. To avoid electric shock, do not touch any naked conductor with your hand or skin. Do not ground
yourself while using the meter.
12. Be aware that an input jack connected to a powered circuit may also create potential current at all other
input jacks.
13. CAT II - Measurement Category II is for measurements performed on circuits directly connected to low
voltage installation. (Examples are measurements on household appliances, portable tools and similar
equipment). Do not use the meter for measurements within Measurement Categories III and IV.
TOOL USE AND CARE
1. Use the correct tool for the job. Do not force a tool or attachment to do the work of a larger industrial tool.
Maximize tool performance and safety by using the tool for its intended task.
2. This tool was designed for a specific function. Do not modify or alter this tool or use it for an
unintended purpose.
3. Securely hold this tool using both hands, unless it is designed for single hand use. Using a tool with only
one hand can result in loss of control.
4. Maintain tools with care (see Maintenance).
UNPACKING
1. Carefully remove the parts and accessories from the box. Retain packaging material until you have carefully
inspected and satisfactorily installed or operated the tool.
2. Make sure that all items in the parts list are included.
3. Inspect the parts carefully to make sure the tools and accessories were not damaged while shipping.
WARNING! Do not operate the tool if any part is missing. Replace the missing part before operating. Failure to
do so could result in a malfunction and serious personal injury.
PARTS IDENTIFICATION
Contents:
•
Digital Multimeter
•
Test Lead Black (negative)
•
Test Lead Red (positive)
ASSEMBLY
NOTE: When this manual refers to a part number, it refers to the included parts list.
The multimeter comes preassembled. The two test leads are plugged into the appropriate jack based on the
function chosen.
6
Digital Multimeter
For technical questions call: 1-800-665-8685
8347676