Publicité
Les langues disponibles
Les langues disponibles
A D A P T I N G F O R T H E D O C T O R / T E C H N I C I A N
FLEXION-EXTENSION ADJUSTMENT
A
Remove the screws that hold the flexion/extension wedges in place (fig. A)
B
Remove any pre-inserted wedges
C
Insert the wedges with the desired degrees of flexion/extension (fig. B)
such that the notches on the wedges coincide with the slots on the brace
D
Reinsert the screws, making sure they properly fit into the slots.
Securely tighten (fig. A).
E
Make sure that the flexion or extension wedges are set to the same degrees
on both joints.
ADJUSTING THE STOP – 0°/10°/20°/30° (OPTIONAL)
F
Remove the screws that hold the flexion/extension wedges in place (fig. A)
G
Remove any pre-inserted wedges.
H
First insert the extension wedge (the one with only one notch), then the flexion wedge
(the one with two notches).
I
If there are any difficulties inserting the second wedge, scrape off any paint present
in the brace slot or file the wedge notches.
J
Reinsert the screws, making sure they properly fit into the slots. Securely tighten (fig. A).
K
Make sure that the flexion or extension wedges are set to the same degrees on both joints.
A
B
Publicité
