Snowbear TGS-325 Manuel Du Propriétaire page 9

Once your r desired heig
Receiver As ssembly brac cket side, and
there is no movement of
4
5
2
INSTALL 5 5/8-11x3.50" HE
AND WASH HER ON RECE
ASSEMBLY Y SIDE. WASH
NUT ON V ERTICAL POS ST SIDE.
The spread er is ready to o install into yo
Hold the sp preader assem
receiver ass sembly to allo
2" from ano other. When th
assembly's holes aligns
supplied r-c clip in the hitc ch pin hole to
R-CLIP
HITCH PI IN
6
INSTA ALL SPREADE ER ASSEMBLY
RECE EIVER INTO VE
RECE EIVER. ALIGN
DEPT TH ADJUSTME ENT HOLE.
9 9 | P a g g e
ght is determin ned, install th he two 5/8-11x
install washe er and 5/8-11
f the spreader r assembly on
3
EX BOLT
EIVER
HER AND
our vehicle's
mbly up to the e 2" hitch rece eiver, and slid
ow for horizon ntal depth adj
he spreader a assembly is s
with the hitch h receiver, an
secure the as
Y 2"
EHICLE'S 2" H ITCH
ONE HORIZO ONTAL
Sno owBear r
x3.50" hex bo olts and wash
lock nut on v vertical post s
n the receiver r assembly.
hitch receiver r.
de in. There a
ustment in th e vehicle's hi
lid into the hit tch receiver, l
d install the s supplied hitch
ssembly.
ONCE DES
INSTALL S SUPPLIED HIT
R-CLIP TO O SECURE AS
®
Tailg gate Sp preader
O Owner's
ers on the 2"
side. Tighten u until
re three holes s in the sprea ader's 2"
tch receiver. Each hole is spaced
look to see w when one of th he
pin. Insert fu lly, and instal ll the
SIRED HOLE I IS ALIGNED,
TCH PIN AND
SEMBLY.
r (TGS -325)
Re evision 2
Manual