AUTO-HAK J46 Instructions De Montage page 4

FITTING INSTRUCTION
Clamp mark
in acc. with Cables joining
ISO PN
1 L Left directional lights
2 + Rear fog lights
3 31 Ground
4 R Right directional lights
5 58R Right side parking lights
6 54 Stoplights
7 58L Left side parking lights
7
8
5
6
This towing hitch is designed to assembly in following car:
HYUNDAI GETZ, 3/5 doors, produced since 09.2002 till 08.2005,
catalogue number J46 and is prepared to tow trailers max total weight 1100
kg and max vertical load 50 kg.
From manufacturer
Thank you for buying our product. Their reliability has been confirmed in
many tests. Reliability of towing hitch depends also on correct assembly and right
operation. For this reasons we kindly ask to read carefully this instruction and
apply to hints.
5
7
1
4
9
3 2
The towing hitch should be installing in points described by a car producer.
Fitting instructions
1. Disassemble the bumper and its plastic filling
2. Position the towing hitch to the frame of the car (do it such way that the
holes of the towing hitch cover original holes) and fix it using
M12x1,25x35mm (pos. 5).
3. Disassemble the plastic filling after modifing it.
4. Disassemble the bumper after cutting it (see fig.2)
5. Position the ball of towing hitch (pos. 2) and the socket plate (pos. 3)
and fix it with M12x75mm screws (pos. 4) from the towing hitch
accessories.
6. Tighten all nuts and bolts according to the torque shown in the table.
7. Connect to the electric wires according to the instructions of the car.
8. Complete the paint cover of towing hitch (during the mounting paint
cover could be destroyed).
Torque settings for nuts and bolts (8,8):
M 8 25 Nm
M 12 85 Nm
After install the towing hitch you should get adequate note in registration book (at
authorised service station).The car should be equipped with:
Indicators
Tow mirrors
After 1000km check all bolts and nuts. The ball of towing hitch must be always
kept clear and conserve with a grease.
M 10 55 Nm
M 14 135 Nm
NOTE
30
Fig. 2