Urmet 1092 Guide Rapide page 5

TO SELECT THE VIDEO OUTPUT
The 1092/165H camera may use 3 different video outputs, which are on the same BNC connector:
•
High-definition 1080P/720P AHD (Analog High Definition) video output
•
CVBS standard interlaced video output
•
Video output in COMET mode
If pressing the RIGHT button for a few seconds, you can select the 1080P AHD video output. If pressing
the LEFT button, you can select the CVBS video output.
With camera in CVBS mode and after having switched off and then on, the UP button allows to select the
video output to 720P (with reduction of the angle view). Pressing the RIGHT button, the 1080P video output
is selected again.
You can enter the COMET video mode if you select an OSD menu item and if the video signal is in CVBS
(ADJUST menu).
NOTE: COME option is available only with the CVBS video output.
The presence or absence of this option therefore permits to identify if the camera is using the CVBS or
AHD video output.
ATTENTION: in case of missing video on the connected device (monitor or DVR), verify that the
selected video output matches with the one selected on the device
In case of missing images in a DVR with AHD and CVBS inputs, try the following steps:
1. Leave a single camera connected to the channel 1 of the DVR
2. Press the button for few seconds the RIGHT and LEFT until the image appears on the
screen
3. If case of missing image again, press the UP button to verify the type of input selected
on the DVR menu
MENU USE
The camera ref. 1092/165H uses a multi-level menu that allows to enable/disable or change camera
settings.
Press the SET button while the camera is on and operating to use the button and access the main menu.
MENUS SYSTEM DESCRIPTION
Once the menu access command has been performed pressing the central button, the access first screen
will be displayed.
Displayed items can be selected by pressing the down button.
Once the item has been selected, the parameter can be changed using the right button and choosing
among the available options, that can be displayed by pressing repeatedly the button.
By selecting the item associated to the symbols
other changes can be performed.
To quit the menu or the submenu and confirm the executed changes, select the item EXIT
and press the central button.
Quick guide and complete user manual of the product are available
at the following link
Quick guide and complete user manual of the product are also available for DOWNLOAD from the URMET
website under the section USER MANUALS.
DS1092-348B
or it is possible to access to the next submenu, where
SAVE&END
5