AUTO-HAK T41 Instructions De Montage page 4

FITTING INSTRUCTION
Clamp mark
in acc. with
Cables joining
ISO PN
1 L Left directional lights
2 + Rear fog lights
3 31 Ground
4 R Right directional lights
5 58R Right side parking lights
6 54 Stoplights
7 58L Left side parking lights
17
15
16
6
4
6
15
3
7
This towbar is designed
KIA SORENTO, 5 doors (BL), produced since 09.2002 till 07.2006, catalogue
no. T41 and is prepared to tow trailers max total weight 2800 kg and max vertical
load 112 kg.
From manufacturer
Thank you for buying our product. Their reliability has been confirmed in
many tests. Reliability of towbar depends also on correct assembly and right
exploit. For this reasons we kindly ask to read carefully this instruction and apply
to hints.
The towbar should be install in points described by a car producer.
6
4
6
14
1
5
2
8
Fig.1
to assembly in following
1. Take out a spare wheel.
2. Disassemble a bumper.
3. Unscrew transverse reinforcement (not used any more).
4. Put main bar (pos. 1) to frame of car in this way, so holes in towbar agree to
original holes and fix all using bolts M12x45mm (pos. 6) and
M10x1,25x35mm (pos. 8) – see figure 1.
7
5. Fish-plates pos. 4 put as shown in the figure and fix using bolts M12x45mm
(pos. 6) and bolts M12x40mm (pos. 7).
8
6. Assemble bumper after cut out his fragment – see fig. 2.
7. Fix tight all bolts according to the torque shown in the table.
8. Fix tow-ball (pos. 2) using bolts M12x70mm (pos. 5) from accessories.
9. Fix the socket plate (pos. 3) as shown on the drawing.
10. Connect electric wires of 7-poles socket according to the instruction of the car.
(Recommend to make at authorized service station)
11. Complete the paint coating damaged during instalment.
cars:
M6 - 11 Nm
M12 - 87 Nm
After install the towbar you should get adequate registration in registration book
(at authorised service station).The car should be equipped with:
Indicators
Tow mirrors
After 1000km check all bolts and nuts. The ball of towbar must be always kept
clean and conserve with a grease.
The instruction of the assembly
30
Torque settings for nuts and bolts (8,8):
M8 - 25 Nm
M14 - 138 Nm
NOTE
Fig. 2
M10 - 50 Nm
M16 - 210 Nm