AUTO-HAK G33 Instructions De Montage page 4

FITTING INSTRUCTION
Clamp mark
in acc. with Cables joining
ISO PN
1 L Left directional lights
2 + Rear fog lights
3 31 Ground
4 R Right directional lights
5 58R Right side parking lights
6 54 Stoplights
7 58L Left side parking lights
9
6
5
11
B
This towing hitch is designed to assembly in following cars:
RENAULT MEGANE ESTATE, produced since 03.1999 till 07.2003,
catalogue no. G33 and is prepared to tow trailers max total weight 1350 kg
and max vertical load 75 kg.
From manufacturer
Thank you for buying our product. Their reliability has been confirmed in
many tests. Reliability of towing hitch depends also on correct assembly and
correct exploitation. For this reasons we kindly ask to read carefully this
instruction and apply to hints.
The towing hitch should be install in points described by a car producer.
6
17
16
12
1
12
A
7
3
18
12
1. From below the car, in rear slice, find plugged holes (on the
10
left and right side). Open it and put caget nut in (pos. 16).
2. Main bar of the towing hitch (pos. 1) put from below and
through holes (pos. A) and fix by bolts M8 as shown on the
figure (use big washers pos. 18).
4
3. In original holes in chassis members put distance sleeves (pos.
B
6) – from outside.
11
4. To installed main bar (pos. 1) fix side brackets (pos. 4 and 5).
Use bolts M10x30mm (pos. 11) through holes (pos. B).
5. Fix elements (pos. 4 and 5) through placed distance sleeves in
chassis members and holes of the towing hitch by bolts
M10x90mm (pos. 10) and by bolts M10x120mm (pos. 9).
6. Fix tow-ball (pos. 2) and socket plate (pos. 3) using bolts
A
8 M12x75mm (pos. 7) and M12x70mm (pos. 8) from
accessories.
7. Tighten all bolts according to the torque shown in the table.
8. Connect electric wires of 7-poles socket according to the
instruction of the car. (Recommend to make at authorized
service station)
2
9. Complete paint layer damaged during installation.
M6 - 11 Nm
M 12 - 87 Nm
After install the towing hitch you should get adequate note in
registration book (at authorised service station).The car should be
equipped with:
• Indicators
• Tow mirrors
After 1000km check all bolts and nuts. The ball of towing hitch must
be always kept clear and conserve with a grease.
Assemble instruction
Torque settings for nuts and bolts (8,8):
M 8 - 25 Nm
M 14 - 138 Nm
NOTE
M 10 - 50 Nm
M16 - 210 Nm