Cutting Head: Use And Maintenance; Blade Maintenance - BELLOTA EPR132P Guide De L'utilisateur

4. Cutting head: use and maintenance

4.1 Blades maintenance
Please cut off the power source of the shears before operation.
•
Refuel lubricating oil before using the blade or after it is used for more than 4h.
•
For correct refueling mentioned above, the blade needs to be opened.
BLADE REFUELING
Fueling hole in the pin hole of the blade on the back of the shears. Squeeze the lubricating oil from the oil
bottle into the fueling hole and cut nothing for several times to make the lubricating oil evenly distributed.
TRANSMISSION GREASING
Open the cover that protects the transmission. Remove dirt from the area with a damp brush or cloth.
Apply lithium grease in the contact area of the transmission and close the cover again.
TIGHTNESS ADJUSTMENT OF THE BLADE
Please cut off the power source of the shears before operation.
Check the tightness of the blade before use. A blade with proper tightness will not swing left and right.
Proper tightness of the blade will make it labor-saving when pruning using the shears.
Caution: When the blade is closed, the blade should not have a lateral swing. Lateral swing is is not normal,
it will create a gap between blade and counter-blade. This will make the theeth of the gears not to work
properly and will damage the mechanical structure of the machine.
REPLACE THE BLADE
Please cut off the power source of the shears before operation.
When the entire length of the moving blade no longer matches the counter blade, or if the blade after grin-
ding is still not clean after cleaning, it is recommended to replace the blade:
1. For safety, please power off before replacement and remove the battery.
2. Follow the steps below to replace the blade.
3. After the replacement, clean it, connect the battery, check the power and close the blade.
Refueling place of
lubricating oil
49