Publicité
Les langues disponibles
Les langues disponibles
Translation of the original instructions
LED Indication Function
The Battery Pack has a "SW" button and 4-step green LEDs for indicating remaining capacity status.
The fuel gauge green LED will indicate within 3 seconds when the "SW" button is momentarily pressed.
Remaining Capacity LED Indication
LED 1 (green)
LED 1, 2 (green)
LED 1, 2, 3 (green)
LED 1, 2, 3, 4 (green)
OPERATING INSTRUCTIONS
Removing or Installing Battery Pack (See Fig.1 Fig.2 )
1. Always switch off the machine before insertion or removal of the battery pack.
2. To remove the battery pack, push the button on the battery pack and pull the tool unit
from the battery pack in the direction.
3. To insert the battery pack, align the tool unit slides with the battery pack sliding groove
and push the tool unit into place. The tool unit can be slide into battery pack in two direc-
tions.
4. Do not force the battery pack in sliding it into tool unit. If the battery pack does not slide
in easily, it is not being inserted correctly.
Charging the Battery Pack (See Fig.3)
1. Plug the fast charger into the power source.
2. Slide the battery pack into the charger as the arrow direction shown on the charger.
3. Push the battery pack into place and make sure the red light on the charger is "ON". The
battery pack is now starting the charging cycle.
4. After finish the charging cycle, the light will turn into green. The battery pack is now
ready for use.
5. Your new battery pack is not charged. You need to charge it before use.
6. Always use the specified charger to charge the battery. When the battery pack is inserted
into the charger correctly, the red light will come on and charging will begin. .
7. When you charge a new battery pack or a battery pack which has not been used for a
long period, it may not accept a full charge. This is a normal condition and does not indi-
cate a problem. You can recharge the battery pack fully after discharging it completely a
couple of times.
8. Unplug the charger from the power source after finish the charge.
9. Please remove the battery from the unplugged charger for storage.
12
CORDLESS IMPACT SCREWDRIVER
RC Status
0%- 25%
26%-50%
51%-75%
76%-100%
EN
2
1
Fig.1
Fig.2
Fig.3
Publicité
