Elipson A680 Mode D'emploi page 10

EN
NOTE : THE AMPLIFIER HAS A FEW SECONDS POWER CYCLE PERIOD
BEFORE IT WILL PLAY AN AUDIO SIGNAL IF EITHER THE AUTO OR TRIGGER
ARE SELECTED. THIS IS NORMAL AND REQUIRED TO COMPLY WITH THE
EU < 0.5 WATT ERP DIRECTIVE.
BUS A & B INPUTS
There are "right" and "left" RCA style connectors labeled as "A" & "B". These
inputs are used for sending a single audio source (i.e. CD, Tuner, MP3 etc.)
to more than one zone. For using this feature correctly, see "Connecting the
Amplifier" later in this manual.
BUS A & B OUTPUTS
There are "right" and "left" labeled as "A" & "B". These outputs are used to
loop the audio source that is connected to the "BUS INPUTS" out to a second
A680.
INDIVIDUAL ZONE LINE INPUTS
These RCA style input connectors are the audio inputs for each individual
channel of the amplifier. These inputs are to have audio sources dedicated
to a single channel or zone on the amplifier. We suggest using a good quality
RCA audio cable for best performance. The RCA inputs are labeled "Left"
and "Right".
BRIDGE/NORMAL
This is used to switch each individual zone between stereo, or bridged.
BUS/LINE IN SWITCH
This is used to indicate which input the individual channel or BUS will receive
audio signal from the source.
18
GAIN ADJUSTMENT
This is an adjustment for the different voltage inputs with each source. Set the
control so that the speakers are not distorting.
POWER SUPPLY USB
5V/2A USB
SPEAKER TERMINALS
These Phoenix type terminal connectors are used to connect the speaker to
each zone.
VOLTAGE SWITCH
Switch between 115V/230V depending on your location.
3-CONDUCTOR AC CORD RECEPTACLE W/FUSE
A standard male receptacle that fits a 3-conductor power cord.
19