Step 3: Configure The Router - Linksys Broadband Serie Guide De Démarrage Rapide

Masquer les pouces Voir aussi pour Broadband Serie:
Table des Matières

Publicité

Les langues disponibles
  • FR

Les langues disponibles

  • FRANÇAIS, page 17
D. Select Internet Protocol
(TCP/IP), and click the
Properties button.
E. Select Obtain an IP address
automatically. When the
new window appears, click
the OK button. Click the OK
button again (or the Close
button if any settings were
changed) to complete the PC
configuration.
F. Restart your computer.
Proceed to Step 3: Configure the Router.
14
IInstant Broadband
D
E
®
EtherFast
Series
®

Step 3: Configure the Router

In Step 3, you will configure the Router so it will be able to access the Internet
through your Internet Service Provider (ISP). You will need the setup informa-
tion provided by your ISP. If you do not have this information, contact your ISP
before proceeding. To find out what questions you should ask your ISP, refer to
Question #1 in the "Help" section.
The instructions from your ISP tell you how to set up your PC for Internet
access. Because you are now using the Router to share Internet access among
several computers, you will use the setup information to configure the Router
instead of your PC.
A. Open your web browser. (It
is all right if you get an error
message
Continue following these directions.) Enter http://192.168.1.1 in the web
browser's Address field. Press the Enter key.
B. An Enter Network Password window, shown in Figure B
(Windows XP users will see a Connect to 192.168.1.1 window, shown in
Figure B
case letters in the Password field (admin is the default user name and pass-
word). Then click the OK button.
B
1
Cable/DSL Routers
Note: You only need to configure the Router once using any com-
puter you have set up.
A
at
this
point.
). Leave the User Name field empty, and enter admin in lower-
2
B
Screen for BEFSX41
, will appear
1
2
15

Publicité

Table des Matières
loading

Table des Matières