BoomToneDJ KUB 200 GALAXIE Mode D'emploi page 22

Troubleshooting
There is no replacement part inside. Please contact your dealer for any
Following are a few common problems that may occur during operation. Here are some
suggestions for easy trouble shooting:

The fixture does not work, no light
o Check the connection of power and main fuse.
o Measure the mains voltage on the main connector.

Not responding to DMX controller
o DMX LED should be on. If not, check DMX connectors, cables to see if link
o If the DMX LED is on and no response to the channel, check the address
o If you have intermittent DMX signal problems, check the pins on
o Try to use another DMX controller.
o Check if the DMX cables run near or run alongside to high voltage cables

Some fixtures don't respond to the easy controller
o You may have a break in the DMX cabling.
o Check the LED for the response of the master/ slave mode signal.

No response to the sound
o Make sure the fixture does not receive DMX signal.
o Check microphone to see if it is good by tapping the microphone.
NEVER OPEN THE FIXTURE
properly.
settings and DMX polarity.
connectors or on PCB of the fixture or the previous one.
that may cause damage or interference to DMX interface circuit.
problem.
21