Dimplex DWF5252B Manuel Du Propriétaire page 9

Fireplace Installation
level is centered between the
two black lines.
6. Mark 3 other mounting screw
locations, on the wall, ensur-
ing that the wall bracket stays
level.
7. Install the supplied wall an-
chors on the drywall marked
locations by placing a #2
Phillips screwdriver into the
recess of the anchor.
8. Press the anchor into the wall
in the desired marked posi-
tion while turning the anchor
clockwise until it is flush with
the wall.
9. Insert the wall anchor screws
through the wall bracket and
thread into the wall anchors.
Tighten the screw (Figure 4).
10. Install the remaining screws
through the bracket and into
the wall studs as required.
Figure 4
Screw
Wall
bracket
Wall anchor
Figure 5
!
NOTE: At least two of the
mounting screws must be in-
stalled into a wall stud.
11. Mount the unit on the wall,
so that the tabs on the wall
bracket have been inserted
into the slots on the back of
the firebox, as shown. (Figure
5)
12. Carefully pour and evenly
distribute the supplied acrylic
rock media in the Media tray
of the firebox (Figure 6).
13. Hang the front glass as-
sembly on the mounts of the
firebox and secure the glass
onto the unit by installing the
retaining screws (Figure 7).
14. Excess electrical cord can be
inserted back into the bottom
of the unit, into the cord stor-
age area.
9