Troubleshooting - Sub-Zero IW30CILH Guide D'utilisation Et D'entretien

T R O U B LE S HO O T I NG

Troubleshooting

SE RVI C E I NDI CAT O R
flashes in control panel display.
• Verify the condenser is clean.
• Turn the unit off at the control panel, then on. If the
indicator continues to flash, contact Sub-Zero Factory
Certified Service.
U N IT O P E R AT I O N
No lights or cooling.
• Verify power is on.
• Verify electrical power to the unit and home circuit
breaker is on.
No lights.
• The door/drawer may have been left ajar which has dis-
abled the lights to eliminate excess heat. If the lights are
out, close the door/drawer for one hour. If the lights are
still out, contact Sub-Zero Factory Certified Service.
• Cabinet lighting must be replaced by Sub-Zero Factory
Certified Service.
Frost, condensation, or ice build up inside unit.
• Verify the condenser is clean.
• Verify the door/drawer is closing properly.
• Verify the door/drawer has not been left ajar.
• Verify the door/drawer gasket does not have rips or
tears. If it does, contact Sub-Zero Factory Certified
Service.
• If icing is heavy, turn the unit off and use a hair dryer to
melt ice. The hair dryer should be set on low and kept
moving at all times. Once the ice has melted, wipe up
any water with a cloth or paper towel.
High temperatures, the unit runs excessively or is giving
off too much heat.
• Verify the condenser is clean.
• Verify the door/drawer is closing properly.
• Verify the door/drawer has not been left ajar.
• Increased ambient temperatures may cause the com-
pressors to run longer.
• If the temperature display shows 45° and 55°, but is not
cooling, the unit may be in showroom mode. Contact
Sub-Zero Customer Care at 800-222-7820.
O D OR
• The unit should be cleaned before using for the first time.
This will clear any odors that may have been trapped
during shipping.
• Uncovered food could create an odor which may require
cleaning.
|
subzero.com 13